1. When moving your microscope, always carry it with both hands (Figure 1, below). Grasp the arm with one hand and place the other hand under the base for support. 2. Turn the revolving nosepiece so that the lowest power objective lens is "clicked" into position (This is also the shortest objective lens).
1.在移動時你的顯微鏡,總是攜帶它用兩只手 (圖 1,下方)。把握的胳膊用一隻手,放在支援的基礎下另一隻手。2.轉動物鏡轉換器,以便最低功率物鏡"按一下"到 (這也是最短的物鏡) 的位置。
3. Your microscope slide should be prepared with a coverslip or cover glass over the specimen. This will help protect the objective lenses if they touch the slide. Place the microscope slide on the stage and fasten it with the stage clips. You can push down on the back end of the stage clip to open it.
4. Look at the objective lens and the stage from the side (Figure 2) and turn the coarse focus knob so that the objective lens moves downward (or the stage, if it moves, goes upward). Move it as far as it will go without touching the slide!
5. Now, look through the eyepiece and adjust the illuminator (or mirror) and diaphragm (Figure 3) for the greatest amount of light
3.您的顯微鏡幻燈片應在試樣準備用蓋玻片或蓋板玻璃。這將有助於保護目的鏡片,如果他們接觸的幻燈片。在舞臺上放置顯微鏡幻燈片和緊固它與舞臺剪輯。你可以按下後端的舞臺剪輯以將其打開。
4.看看物鏡和階段從側面 (圖 2),旋鈕粗焦點,以便客觀鏡頭向下移動 (或舞臺上,如果它移動,向上進入)。移動到它它會沒有觸及幻燈片 !
5.現在,看看透過接目鏡和調整照明器 (或鏡像) 和橫隔膜 (圖 3),最大的光量
1.在移動時你的顯微鏡,總是攜帶它用兩只手 (圖 1,下方)。把握的胳膊用一隻手,放在支援的基礎下另一隻手。2.轉動物鏡轉換器,以便最低功率物鏡"按一下"到 (這也是最短的物鏡) 的位置。
3. Your microscope slide should be prepared with a coverslip or cover glass over the specimen. This will help protect the objective lenses if they touch the slide. Place the microscope slide on the stage and fasten it with the stage clips. You can push down on the back end of the stage clip to open it.
4. Look at the objective lens and the stage from the side (Figure 2) and turn the coarse focus knob so that the objective lens moves downward (or the stage, if it moves, goes upward). Move it as far as it will go without touching the slide!
5. Now, look through the eyepiece and adjust the illuminator (or mirror) and diaphragm (Figure 3) for the greatest amount of light
3.您的顯微鏡幻燈片應在試樣準備用蓋玻片或蓋板玻璃。這將有助於保護目的鏡片,如果他們接觸的幻燈片。在舞臺上放置顯微鏡幻燈片和緊固它與舞臺剪輯。你可以按下後端的舞臺剪輯以將其打開。
4.看看物鏡和階段從側面 (圖 2),旋鈕粗焦點,以便客觀鏡頭向下移動 (或舞臺上,如果它移動,向上進入)。移動到它它會沒有觸及幻燈片 !
5.現在,看看透過接目鏡和調整照明器 (或鏡像) 和橫隔膜 (圖 3),最大的光量
6. Slowly turn the coarse adjustment so that the objective lens goes up (away from the slide). Continue until the image comes into focus. Use the fine adjustment, if available, for fine focusing. If you have a microscope with a moving stage, then turn the coarse knob so the stage moves downward or away from the objective lens.
7. Move the microscope slide around so that the image is in the center of the field of view and readjust the mirror, illuminator or diaphragm for the clearest image.
8. Now, you should be able to change to the next objective lenses with only minimal use of the focusing adjustment. Use the fine adjustment, if available. If you cannot focus on your specimen, repeat steps 4 through 7 with the higher power objective lens in place. Do not allow the objective lens to touch the slide!
9. The proper way to use a monocular microscope is to look through the eyepiece with one eye and keep the other eye open (this helps avoid eye strain). If you have to close one eye when looking into the microscope, it's ok. Remember, everything is upside down and backwards. When you move the slide to the right, the image goes to the left!
6.慢慢轉動粗調整以便物鏡上升 (從幻燈片上)。繼續,直到圖像來成為關注的焦點。使用的精細的調整,如果可用,精細聚焦。如果你有一台顯微鏡與移動的階段,然後的旋鈕粗所以舞臺移向下或從物鏡。
7.移動顯微鏡幻燈片圖像是在視野的中心和調整的鏡子,照明器或隔膜的最清晰的圖像。
8.現在,您應該能夠將更改為僅使用很少的聚焦調整下的物鏡。使用的精細的調整,(如果可用)。如果你不能專注于你的標本,重複步驟 4 到 7 與高功率物鏡在的地方。不允許物鏡觸摸幻燈片 !
9.適當的方式使用單目顯微鏡是透過接目鏡用一隻眼睛看,保持另一隻眼睛開放 (這有助於避免眼睛疲勞)。如果你要閉上一隻眼睛,當看著顯微鏡,它是確定的。請記住,一切都是顛倒的。當你向右移動幻燈片時,圖像走到左邊 !
10. Do not touch the glass part of the lenses with your fingers. Use only special lens paper to clean the lenses.
11. When finished, raise the tube (or lower the stage), click the low power lens into position and remove the slide.
12. Always keep your microscope covered when not in use. Dust is the number 1 enemy!
Remember, microscopes are expensive scientific instruments. Handle them properly and carefully and they will last for many years!
10.不要觸摸用你的手指鏡頭的玻璃部分。使用只有特殊鏡頭紙清潔鏡片。
11.完成後,提高管 (或較低的階段),進入位置按一下低功率透鏡和刪除幻燈片。
12.始終保持你在不使用時蓋的顯微鏡。灰塵是 1 號敵人 !
記住,顯微鏡是昂貴的科學儀器。妥善而謹慎地處理它們,他們將會持續很多年 !
7. Move the microscope slide around so that the image is in the center of the field of view and readjust the mirror, illuminator or diaphragm for the clearest image.
8. Now, you should be able to change to the next objective lenses with only minimal use of the focusing adjustment. Use the fine adjustment, if available. If you cannot focus on your specimen, repeat steps 4 through 7 with the higher power objective lens in place. Do not allow the objective lens to touch the slide!
9. The proper way to use a monocular microscope is to look through the eyepiece with one eye and keep the other eye open (this helps avoid eye strain). If you have to close one eye when looking into the microscope, it's ok. Remember, everything is upside down and backwards. When you move the slide to the right, the image goes to the left!
6.慢慢轉動粗調整以便物鏡上升 (從幻燈片上)。繼續,直到圖像來成為關注的焦點。使用的精細的調整,如果可用,精細聚焦。如果你有一台顯微鏡與移動的階段,然後的旋鈕粗所以舞臺移向下或從物鏡。
7.移動顯微鏡幻燈片圖像是在視野的中心和調整的鏡子,照明器或隔膜的最清晰的圖像。
8.現在,您應該能夠將更改為僅使用很少的聚焦調整下的物鏡。使用的精細的調整,(如果可用)。如果你不能專注于你的標本,重複步驟 4 到 7 與高功率物鏡在的地方。不允許物鏡觸摸幻燈片 !
9.適當的方式使用單目顯微鏡是透過接目鏡用一隻眼睛看,保持另一隻眼睛開放 (這有助於避免眼睛疲勞)。如果你要閉上一隻眼睛,當看著顯微鏡,它是確定的。請記住,一切都是顛倒的。當你向右移動幻燈片時,圖像走到左邊 !
10. Do not touch the glass part of the lenses with your fingers. Use only special lens paper to clean the lenses.
11. When finished, raise the tube (or lower the stage), click the low power lens into position and remove the slide.
12. Always keep your microscope covered when not in use. Dust is the number 1 enemy!
Remember, microscopes are expensive scientific instruments. Handle them properly and carefully and they will last for many years!
10.不要觸摸用你的手指鏡頭的玻璃部分。使用只有特殊鏡頭紙清潔鏡片。
11.完成後,提高管 (或較低的階段),進入位置按一下低功率透鏡和刪除幻燈片。
12.始終保持你在不使用時蓋的顯微鏡。灰塵是 1 號敵人 !
記住,顯微鏡是昂貴的科學儀器。妥善而謹慎地處理它們,他們將會持續很多年 !